anyone Know daul 12v to a 12v wallwart.

[ebacon]

Originally Posted by one1

what about this http://www.ebay.com/itm/HIGH-CAPACTI...item2c73e9690a Larger mah value means longer lasting time of battery.
Duration of power up to 8 hours.
Capacity of battery: 1800mAh.
Input voltage: DC 12.6V.
Output voltage: DC 12V .

Two of those will give you +/- 12V.

[ebacon]

Originally Posted by Ike Bana

What, in the name of all that is holy and revered, is a walwart?

hehe.

I am not alone in being clueless.

[one1]

actualy it is 15volts

LM4610 + NE5532 Preamplifier tone board



Voltage: Dual AC15V-18V:

Circuit board size: 117X68MM (the potentiometer-free)

Potential functions: 3D, bass, treble, balance, volume

The distance between the potentiometer: 25MM

Two switching functions: on the left for the 3D switch, the right loudness switch

● Input impedance 30kω, low output impedance of 20ω;

● The volume adjustment range is 75dB; the balance adjustment ranges from 1 ~~ 20dB;

● bass adjustment (40Hz when) ± 15dB treble adjustment (16kHz) is ± 15dB;

● Total harmonic distortion is only 0.0003;

● SNR up to 80dB;

● Frequency width of 250kHz;

● The maximum signal input, the output voltage of 1.5V;

● Two channel balance error is less than 1.5dB;

● Power common-mode rejection ratio of 60dB. contact me for the datasheet

[one1]

Originally Posted by ebacon

hehe.

I am not alone in being clueless.

i just learned last week ,hey gotta start somewere.

[one1]

got some research to do but I will submit it here defore I drop a dime.

[one1]

hmmm 15 volts is a hard one to find,will 12v be ok if I get the amps up a bit the preamp is below 2A I know.

[one1]

Originally Posted by ebacon

Two of those will give you +/- 12V.

how are they wired together? series,parelel

[ebacon]

Originally Posted by one1

how are they wired together? series,parelel

In series. The +/- junction goes to the "0" or "GND" terminal of the preamp. The remaining + and - battery poles go to their respective preamp terminals.

[Pio1980]

Batteries are wired in series with the "joint point" being center neutral ground. The batteries can then be charged in series, after disconnecting from the preamp, with an appropriate 24 volt charger. This is how I do it but with a double pole double throw charging transfer switch.

Sent from my SM-N900V using Tapatalk

[ebacon]

Originally Posted by one1

easy enough,ok I came across this would it work Volts 12 V Amp Hour 5 AH
Chemistry SLA / AGM Terminal .187
Length 3.54 in Width 2.76 in
Height 4.21 in Weight 3.09 Lbs
Warranty 2 year Quantity 2
http://www.ebay.com/itm/Max-Life-12V...item417dd9a760

and how would I charge it.I have a car charger or could I use a house adapter.

That's overkill. Those are scooter batteries.